2M Extension Cable for Control Handle of Synchronous Controller with Adapter (Model 0043212)

2M Extension Cable for Control Handle of Synchronous Controller with Adapter (Model 0043212)The control handle cable for the electric linear actuator's synchronous controller is only 2 meters long. If you need a longer cable, please purchase this control handle extension cable. This extension cable is 2 meters long and comes with an adapter. You can use it to extend the distance between the control handle and the synchronous controller.

You can operate as following:

Adjust the midpoint offset of the joystick

when it moves to the position of another magnetic switch

394 in] Front / Rear Connector Mounting Hole Diameter 5mm [0

Different Speeds and Corresponding Maximum Thrust No-load Speed Full load Speed Maximum Thrust Self-locking Force 5mm/s 2

resulting in a retraction length of 465 mm

Stroke and Length (Model 0041943-4) Parameter Value Stroke 600 mm Retraction Length 780 mm (center distance between two mounting holes when the linear actuator is fully retracted) Extension Length 1380 mm (center distance between two mounting holes when the linear actuator is fully extended) The linear actuator has two built-in limit switches

“A006” means 6 seconds

This is a IP67 waterproof and low noise linear actuator with adjustable stroke and standard stroke of 350 mm

This is a micro industrial electric linear actuator with a 300 mm stroke and stainless steel telescopic tube

2) In Momentary mode: For example

a remote receiver